What's included
- Motor switched off and priming plug opened
- Pump and suction line filled to push out air
- Suction joints checked for air leaks
- Foot valve checked where it can be reached
- Run test until water reaches the tank
What's not included
- A new foot valve or pipe, quoted before fitting
- Motor winding, capacitor or electrical faults
- Borewell and submersible pumps
How the visit goes
- 1
Stop the motor
The motor is switched off so it does not run dry while the plumber works.
- 2
Fill and bleed
The priming plug is opened and water is poured in until the air bubbles out.
- 3
Find the air leak
Suction joints and the foot valve are checked, since air got in somewhere.
- 4
Run and confirm
The motor is restarted and run until steady water reaches the tank.
What we need from you
- Motor switched off if it runs without lifting water
- A bucket of water near the motor
- Access to the sump or suction pipe
Questions about this service
Why does my motor keep getting air locked?
Usually a leaking suction joint or a worn foot valve lets air in. The plumber checks both after clearing the lock.
Is it safe to keep running the motor?
No. Running dry can overheat and damage the pump. Switch it off until the air is cleared.
What if the motor still does not lift water?
If the pipes are sound, the fault may be electrical or inside the motor, which needs a motor mechanic.
Reviews
No reviews yet. Be the first to book and review this service.
